Techniques Used to Clean Up Mold

While there are a lot of different ways to kill and remove mold from your home, depending on what the mold has gotten on or into, you may want to use one technique before trying the other. Note that killing mold and removing it is not one and the same thing. Killing mold is just that: terminating the life of the mold so that it ceases to continue growing. Since the mold is dead, it cannot cause infections if it gets onto your skin because it must be alive to change into yeast. However, the bad thing about simply killing the mold is the fact that it does not have to be alive in order to cause an allergic reaction in a person. The mold spores remain intact and in their same physical condition as before, so when the spores enter the body, the body does not realize that the spores are dead and pose no threat.

You can use a wet vacuum to clean up standing water in areas of your home where it exists, since this is where mold likes to grow the most. This is especially true if there are any cellulose-based materials that have been soaked by it, such as paper, cardboard, and anything else that can be decomposed. You should only use these vacuums when the surface is wet, so mold spores do not get tossed into the air. The equipment should be cleaned and dried thoroughly after you use it, since mold and its spores can attach themselves to it.

Sometimes you can use a damp paper towel or damp cloth to clean mold off of surfaces that are nonporous, like countertops or a vinyl floor, but if you are going to do this, using chemicals that kill mold are a must. Trying to clean mold off of porous surfaces like drywall usually ends in heartbreak, because most of the time they cannot be saved. The entire item is usually too contaminated. Clothes can be saved sometimes, but this is only because of the very thin nature of the item. Thick porous surfaces like drywall are simply too thick for it to be feasible to try to save them.

HEPA filter-equipped vacuum cleaners are good to have around if you are trying to remove as much mold from your home as possible, since these vacuum cleaners will filter clean air back into the room as you vacuum. The mold spores and dirt particles will get caught in the filter and are easily disposed of afterward. When you dump the contents of the receptacle, do not touch it with your bare hands. Wear gloves if you can and do not let it come into contact with your skin. Try not to stir the contents up and do not breathe them.






Jim Corkern is a writer and promoter of quality
Miami Residential Water Damage Restoration Contractors and
Orlando water Damage companies